How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Richard Your Own Question
Richard
Richard, Jaguar Technician
Category: Jaguar
Satisfied Customers: 15437
Experience:  12 years at a Ford/Lincoln Mercury and Jaguar dealer as technician and shop foreman.
10437779
Type Your Jaguar Question Here...
Richard is online now
A new question is answered every 9 seconds

Jaguar Vanden Plas: vanden plas rear window will not stay up.

Customer Question

vanden plas rear window will not stay up. automatically goes up and down
Submitted: 1 year ago.
Category: Jaguar
Expert:  Richard replied 1 year ago.
Hello and welcome to justanswer.com
What year is your XJ? SO the passenger rear window will go up but falls back down? If you try to move the glass up and down is there movement
Customer: replied 1 year ago.
It does not fall down. It is like someone is pushing the up down control and it usually stops about a third of the way up . It does this while driving and some times you can send it up but then later it will go down. If the control on the driver and pasenger rear door do not put it up you can usually turn the car off and then turn the ign switch to the almost start position and then the controls will work.
Expert:  Richard replied 1 year ago.
Ok what year is your vehicle?
Customer: replied 1 year ago.
2001
Expert:  Richard replied 1 year ago.
Ok it is very possible we have a sticking switch. Could be the master switch or the rear door switch. what I would try is disconnecting the rear door switch and see if the problem is no longer present. IN order to disconnect the switch we will need to remove the panel.
Here's the procedure to remove the door panel. First remove the small screw cover from inside the inner door handle. Remove the screw then pop off the back of the wood veener and slide it back to disengage it from the door handle housing. Remove the screws under the armrest then the panel will come off by poping it off and lifting up. Use these links.
http://www.justanswer.com/uploads/crzydrvr00/2009-07-29_145400_2001_xj_door_panel_1.pdf
http://www.justanswer.com/uploads/crzydrvr00/2009-07-29_145442_2001_xj_door_panel_2.pdf
Customer: replied 1 year ago.
I see no screws or a way to get the panel off and no screws under the arm rest. Does prying on the veneer break it?
Expert:  Richard replied 1 year ago.
There should be screws. Please use the links as a ref

Related Jaguar Questions