Ok we may have a problem with the contacts in that overhead console. Using finger pressure starting from the front of the console by the windshield pull gently down to disengage the console then check the electrical connector.

Ok this does mean you have a rolling code door opener when it flashes yellow. There is a separate procedure you need to do. This should be in the manual.

1. Programme your portable remote control to the vehicle

integrated transmitter as described previously.

2. Remove the cover panel from the GDO receiver. The receiver

would be located by the garage door opener motor.

3. Locate the training button on the GDO receiver. The exact

location and colour of the button may vary by different

manufacturers. If the training button cannot be located,

consult the GDO manual.

4. Press the receiver training button for two seconds.

5. Return to the vehicle and press the integrated transmitter

button for the duration of the rapid flashing yellow indicator

light (one to two seconds). Release the button and then press

the button again to confirm that the integrated transmitter

has been trained to the receiver.

The garage door opener has now been trained to recognise your

vehicle GDO. Either the integrated transmitter or the original

portable remote transmitter can now be used to open the

garage door.