How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Wayne Your Own Question
Wayne
Wayne, Journeyman
Category: Industrial Equipment
Satisfied Customers: 9215
Experience:  worked on lift trucks, and IR air compressors
6825259
Type Your Industrial Equipment Question Here...
Wayne is online now
A new question is answered every 9 seconds

HYSTER 2008 HYSTER H60XM FORKLIFT SN NUMBER H177B18658X NEED

Customer Question

HYSTER 2008 HYSTER H60XM FORKLIFT SN NUMBER H177B18658X NEED TO KNOW WHY AUX LIFT CYLINDER IS OPERATING BEFORE CENTER CYLINDER IS FULLY EXTENDED.
Submitted: 1 month ago.
Category: Industrial Equipment
Expert:  Wayne replied 1 month ago.

HI I'm Wayne

I will help you with this

what you are describing is the

control valve is by-passing internally, causing that

needs to be replaced or rebuilt

I hope this helps you

Hi If this helped you

Please rate my answer 3 or more stars

That is the only way I get credit for the question

Or the money you paid stays at JA and I get nothing for my time

If you need more info use the INFO button

Not the Poor/Bad service

Wayne

Customer: replied 1 month ago.
WHAT CONTROL VALVE WHERE LOCATION AND FUNCTION DO YOU HAVE HYDRAULIC SCHEMATICS????
Expert:  Wayne replied 1 month ago.

HI

The control valve that you use for the hydraulics

to raise ,lower, side shift

No I do not have a schematic

Customer: replied 1 month ago.
HOW DO YOU TEST CONTROL VALVE??
Expert:  Wayne replied 1 month ago.

HI

There is not real test , just disassemble

the valve and rebuild it

Customer: replied 1 month ago.
DO YOU HAVE DISASEMBLY BREAK DOWN?
Expert:  Wayne replied 1 month ago.

HI

I will look

Expert:  Wayne replied 1 month ago.

HI

No no diagram out there

is yours a 3 or 4 spool valve

3 or 4 controls ??

Customer: replied 1 month ago.
3 VALVE
Expert:  Wayne replied 1 month ago.

Thank you

click here for the valve

Wayne

Customer: replied 1 month ago.
THERE HAS TO BE A TEST PROCEDURE.
Expert:  Wayne replied 1 month ago.

HI

OK get a manifold test set , with 2 gauges hooked to it

tee off the lines, need gauges that register 6000 Lbs

see what the pressures are before and during the usage

You will need to rent this as it is over $850.00

Hi If this helped you

Please rate my answer 3 or more stars

That is the only way I get credit for the question

Or the money you paid stays at JA and I get nothing for my time

If you need more info use the INFO button

Not the Poor/Bad service

Wayne

Customer: replied 1 month ago.
WHAT IS THE PRESSURE WHEN OPERATING?
Customer: replied 1 month ago.
WHAT ABOUT GPM?
Expert:  Wayne replied 1 month ago.

HI

GPM , has noting to do with your issue

hook up the gauges , tell me what you have

and we will go from there

Wayne

Related Industrial Equipment Questions