How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis B. Your Own Question
Curtis B.
Curtis B., Technician
Category: Industrial Equipment
Satisfied Customers: 26032
Experience:  Technican turned service manager on multiple lines of equipment used in industry.
30244710
Type Your Industrial Equipment Question Here...
Curtis B. is online now
A new question is answered every 9 seconds

I have a forklift that light botton have went out to much to

Customer Question

i have a forklift that light botton have went out to much to replace want to add toggle switch. need to know what to do to rewire from start. going to key switch then toggle then relay then fuse then light dont know what wire is what

Submitted: 1 year ago.
Category: Industrial Equipment
Expert:  Curtis B. replied 1 year ago.
All you need is voltage to the switch, the toggle switch, and wire to the lights.?? Use voltmeter or test light to find the power wire on the old switch.
Customer: replied 1 year ago.
What about fuse an relay
Customer: replied 1 year ago.
The old botton was run by circuit board
Expert:  Curtis B. replied 1 year ago.
Find a voltage source, take it to the new switch, wire from switch to lights, add fuse, then go to the lights. Lights should light when switch is turned on.

Related Industrial Equipment Questions