How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Your Own Question
Ron
Ron, ASE Certified Technician
Category: Hyundai
Satisfied Customers: 33409
Experience:  35 year in the Auto repiar business ASE Certified
7276279
Type Your Hyundai Question Here...
Ron is online now
A new question is answered every 9 seconds

Have a hyundai santa fe 4 cyl.. just changed the head and

Customer Question

hello, have a hyundai santa fe 4 cyl.. just changed the head and timing belt... now when i start it it runs really rich.. when i unplug the cam sensor it all smooths out for 10 seconds then dies.. any answers?
Submitted: 1 year ago.
Category: Hyundai
Expert:  Ron replied 1 year ago.

Hello and thank you for your question,

Is the check engine light coming on and if so can you tell me what fault code and or codes are setting?

Customer: replied 1 year ago.
no check engine at all
just rough running
Expert:  Ron replied 1 year ago.

If you where not having this problem before the head and timing belt where installed I would go back in and recheck the timing belt alignment.

Customer: replied 1 year ago.
well i have done that.. checked it twice actually.. why would it smooth right out when i unplug the sensor toy the cam.. can it be a bad computer?
Expert:  Ron replied 1 year ago.

Unplugging the cam sensor is only tricking the computer and likely masking the problem. If its an electronic concern there should be a code and or codes setting.

Customer: replied 1 year ago.
okay.. checked everything on this lil car.. and i found that the one and three cylinders are not getting fuel or firing....the plugs are not really soaked so.. i changed around the injectors same thing.. so i ask.. what can it be now.. is there a fuel sensor or something.. there are no codes at all flashing
Expert:  Ron replied 1 year ago.

Are you getting power to the power side of the suspect injecotr and is so are you also getting the ground switching signal from the ECM?

Customer: replied 1 year ago.
is there a limp mode where it shuts down if the crank sensor is faulty.. i'm told it sometimes does not give a code
Customer: replied 1 year ago.
it is two cyl. 1 and 3 that are not firing... well there is spark just no injector interaction

Related Hyundai Questions