Hello I will help you with your question,
Remove the handle cup by removing the screw and sliding to the front and turning the rod retainers on the back of the handle to release the rods
Remove the switch panel by removing the single screw in the bottom of the pull cup and lifting the rear first and pulling the panel up enough to release the electrical connector.
Remove the screws ate the front and rear of the door panel bottom and the two under the plug covers at the front of the panel top.
Remove the panel by prying between the panel and the door and lifting the panel once the panel is free of the door.
let me know how I can help you with this
This is a manual door?
Use a rag to slide between the handle and the door to catch the clip holding the crank onto the regulator shaft and pull the clip free. Watch it they like to go flying so pull slowly until the clip comes out and then the crank slides off the splined shaft
Let me know how I can help you