How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Phil Your Own Question
Phil
Phil, Mechanical Engineer
Category: HVAC
Satisfied Customers: 5648
Experience:  Retired HVAC/ Electrical & Boiler contractor. Industrial
23932409
Type Your HVAC Question Here...
Phil is online now
A new question is answered every 9 seconds

My Carrier furnace model 58PAV070-12 has three burners on a

Customer Question

My Carrier furnace model 58PAV070-12 has three burners on a manifold. When the unit is turned on, the first two burners come on, the third one doesn't, and the unit shuts off. What's up?!?
JA: Did you check the furnace's filters?
Customer: Yes.
JA: Do you plan on doing the work yourself?
Customer: If I can. I'm pretty good with a screwdriver and a pair of pliers!
JA: Anything else we should know to help you best?
Customer: Not that I know of.
Submitted: 23 days ago.
Category: HVAC
Expert:  BillyHvac replied 23 days ago.

Hello,

My name is Billy.

Do your burners look like the link HERE

Customer: replied 23 days ago.
My burners do not look like the burners in the picture.
Expert:  BillyHvac replied 23 days ago.

According to the parts list you have the mono jet burner. The only other burner they used was a ribbon burner like this

If not like either of these I will need a pic as those are the 2 Carrier burners

Customer: replied 23 days ago.
Billy, when you sent the pictures, how do I respond to you, there are not any instructions to do so. The second picture appeared to be
what I have, attached to a three burner manifold.
Expert:  BillyHvac replied 23 days ago.

Ok,

These burners can easily be removed and cleaned.

Grasp burner, tilt front end up and slide burner forward..it should lift up and out..

Then tap out debris. Use a wire brush and clean edges....rub bristles across slots....

The reinstall burners...this should take care of the issues.

Expert:  BillyHvac replied 23 days ago.

if you have the mono jet burners there are 1/4" screws you must remove and they also lift up. forward and out.

Related HVAC Questions