How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask airheatman Your Own Question
airheatman
airheatman, HVAC Technician
Category: HVAC
Satisfied Customers: 7725
Experience:  Furnace, A/C and heat pump specialist.
16514686
Type Your HVAC Question Here...
airheatman is online now
A new question is answered every 9 seconds

Mn#DGATO70BDD, MN# DGATO70BDD evcon direct vent forced air

Customer Question

Mn#DGATO70BDD
JA: I'll do all I can to help. How long have you been dealing with this?
Customer: MN# ***** evcon direct vent forced air furnace in a mobile home. Problem is once unit go thru in sequence air in furnace Purges, electric igniter glow red, then gas comes on flames up for about 5 to 8 seconds then go's off. Replaced flame sensor, centrifugal switch top sensor w/reset button and lower as well. Note: the green light bleaks once.? When it flames out
JA: Did you double-check the thermostat's settings? And what about the filters?
Customer: Functional and brand new
JA: Do you plan on doing the work yourself?
Customer: Yes
JA: Anything else we should know to help you best?
Customer: Yes this past summer we had a small water leak at top of furnace at the exhaust stack and water drip on the cover of main circuit board and found white residue on it.
Submitted: 1 month ago.
Category: HVAC
Expert:  airheatman replied 1 month ago.

Is there a label to tell us what one flash error means? It sounds to me like board may have gotten wet .Board seems to be failing to recognize flame is on.

Related HVAC Questions