How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Phil Your Own Question
Phil
Phil, Mechanical Engineer
Category: HVAC
Satisfied Customers: 5648
Experience:  Retired HVAC/ Electrical & Boiler contractor. Industrial
23932409
Type Your HVAC Question Here...
Phil is online now
A new question is answered every 9 seconds

Need a 4foot by 2sq.in aluminum bar with 50 ports on 2

Customer Question

need a 4foot long by 2sq.in aluminum bar with 50 ports on 2 corners 1/8 in dia .to be placed between a set of dies to pre heat the mold .operating at 14in wc. press must have 100%saftey with a thermocouple and good pilot nat.gas rick at ***********************
Submitted: 12 months ago.
Category: HVAC
Expert:  Gaztech replied 11 months ago.

Ok, sounds like you need this built for you, not sure what your asking, can you give me more info..

Related HVAC Questions