How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask BillyHvac Your Own Question
BillyHvac
BillyHvac, Journeyman HVAC Tech
Category: HVAC
Satisfied Customers: 22120
Experience:  Endorsed for unlimited heating, cooling, oil burners, boilers, refrigeration, hydronics
12672042
Type Your HVAC Question Here...
BillyHvac is online now
A new question is answered every 9 seconds

Frigidaire mini-split frs12pyc1 - originally got error code

Customer Question

Frigidaire mini-split frs12pyc1 - originally got error code E6. Ordered a new control board for the outside unit and installed it. No longer getting E6 code but compressor does not come on. Fan comes on in cooling mode only but not compressor. Left heating mode on for over and hour and nothing happens, no error codes, no compressor, nothing. Filters are clean, tried turning the breaker off and back on. What can I do to get it running?
Submitted: 10 months ago.
Category: HVAC
Expert:  BillyHvac replied 10 months ago.

I am very sorry your question has not been picked up yet.

I just logged on and found you had not been assisted.

Please let me know if you still need help and I will do my best. Please do not "Rate" as we have not worked toward an answer yet.

If you would like to proceed let me know by replying. Once again use reply..not "rate".

Customer: replied 10 months ago.
Do you have a solution?
Expert:  BillyHvac replied 10 months ago.

hello,

have checked the communication cable and wire nuts, any splices etc?...this communication error usually affects everything when it is board...when 1 mode faults it is generally a wire, connection, edge connector etc...

Customer: replied 10 months ago.
All connections are good, no splices, no wire nuts. No longer getting E6 with the new board but it just won't run. It ran fine before E6 appeared with the old board. Checked cables, no splices or wire nuts in the outside or inside units, only in the power supply box. Inside unit it on, remote works to change mode, temp settings, etc and fan runs. Outside unit does not turn on to cool or heat, tried both.

Related HVAC Questions