How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask BillyHvac Your Own Question
BillyHvac
BillyHvac, Journeyman HVAC Tech
Category: HVAC
Satisfied Customers: 22102
Experience:  Endorsed for unlimited heating, cooling, oil burners, boilers, refrigeration, hydronics
12672042
Type Your HVAC Question Here...
BillyHvac is online now
A new question is answered every 9 seconds

Just replaced the blower motor on aH23Q5/6-150. Initializing

Customer Question

HI. Just replaced the blower motor on aH23Q5/6-150. Initializing shows 95VAC at heat lead* then drops to 0 when heat demand kicks in. Any ideas before I consider board bad?
FYI Old motor was tripping breaker.
Submitted: 1 year ago.
Category: HVAC
Expert:  BillyHvac replied 1 year ago.

hello, there is nothing else to consider as you have it narrowed down.

The board is what fried the old motor...now it is time to replace the board. Your test show 100% bad circuit board

Billy

Customer: replied 1 year ago.
I do see the 27VAC on heat & fan leads from thermostat when the motor heat lead reads both 95VAC (is that the giveaway?) AND when it drops to 0VAC (after 2 or 3 quick relay clicks)Not worth checking pressure (or other check switch/sensor)?
Expert:  BillyHvac replied 1 year ago.

not worth the time...the 27 is correct for thermostat voltage but the board is robbing voltage from the 120v.

Your end result is 100% new board

Related HVAC Questions