hello,2008 Crv Ex with only hot air blowing when AC is turned on. Had local shop locate problem, and said the pressure cycling switch needed to be replaced. I ordered the sensor and now would like to know where it is located in vehicle.
Country: United StatesMake: HondaModel: CRV EXYear: 2008
Had local shop isolate the problem, and was advised to replace the cycling switch. This is as far as I've gotten
I WOULD LIKE TO THANK YOU FOR CHOOSING JUST ANSWER, AND FOR ALLOWING ME THE OPPORTUNITY TO ASSIST YOU WITH YOUR AUTOMOTIVE CONCERNS.If the switch you have is the a/c pressure transducer, it is located in the front of the vehicle (in front of the radiator right side on the liquid line) The wire connector disconnects, and the sensor un-screws from the line, Thanks,Please let me know if I can be of any other assistance
30 years of all phases automotive diagnostics and repair
Thanks for the reply. I will rate your response as soon as there's daylight for me to try it.
Sounds good let me know, if I can be of any other assistance to you with this issue
Well, replaced the a/c pressure transducer and had system recharged with freon and tested. Now the shop is saying that the compressor is not getting any ground and therefore not engaging. Is it time to take it to Honda dealership? Or can an electrical shop address this issue. Thanks for any further feedback.