How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tim Mohr Your Own Question
Tim Mohr
Tim Mohr, ASE Master Tech
Category: Honda
Satisfied Customers: 15600
Experience:  30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL
17454363
Type Your Honda Question Here...
Tim Mohr is online now
A new question is answered every 9 seconds

how to remove a power steering pump for a 2000 honda accord

Customer Question

how to remove a power steering pump for a 2000 honda accord coupe ex
Submitted: 5 years ago.
Category: Honda
Expert:  Tim Mohr replied 5 years ago.
Hi, my name is XXXXX XXXXX you have the 4 cyl or the 6 cyl engine?
Customer: replied 5 years ago.
V 6
Expert:  Tim Mohr replied 5 years ago.
I will post the procedure below for this,Tim
Tim Mohr and 6 other Honda Specialists are ready to help you
Expert:  Tim Mohr replied 5 years ago.
Removal and Installation

Replacement

  1. Place a suitable container under the vehicle.
  2. Drain the power steering fluid from the reservoir.
  3. Remove the intake manifold cover.

 



 

  1. Cover the crankshaft pulley with several shop towels to protect if from spilled power steering fluid. Disconnect the pump inlet hose (A) and pump outlet hose (B) from the pump (C), and plug them. Take care not to spill the fluid on the body or parts. Wine off any spilled fluid at once.
  2. Remove the belt (D) by loosening the pump adjusting nut (E), then remove pump mounting bolts (F), nut (G) and pump. Do not turn the steering wheel with pump removed.
  3. Connect the pump outlet hose and inlet hose. Tighten the pump fittings securely.
  4. Loosely install the pump in the pump bracket with the mounting bolts and nut.

 



 

  1. Install the pump belt (A) on the pulley (B). Note these items during belt installation:
    • Make sure that the power steering belt is properly positioned on the pulleys.
    • Do not get the power steering fluid or grease on the belt or pulley faces. Clean off any fluid or grease before installation.
  1. Adjust the pump belt adjustment
  2. Fill the reservoir to the upper level line.
Tim Mohr and 6 other Honda Specialists are ready to help you
Expert:  Tim Mohr replied 5 years ago.

the pictures did not come through, i will post them seperately below,Tim

Expert:  Tim Mohr replied 5 years ago.
graphicgraphic
Expert:  Tim Mohr replied 5 years ago.
Do you need more info on this?