Have a Honda Question? Ask a Honda Repair Expert.
can you elaborate on you question so that I may be able to help you?
we have a 2003 Honda Accord V6
was rear eneded
left rear suspension was replaced
we drove the car after the repairs for 30 mins and no light came on
brakes were worn, so we replaced all four rotors
after driving it for 30 mins
engine light came on
TSC came on
and the Triangle
we did diagnostic and had to replaced the Brake switch
then we replaced the: CHARCOLE CANESTOR
right beside the gas tanks
of course with the 3 valves that are on it
and now we get this code:
84-1 seonsor logic malfunction
DTC 84: TCS Pressure Sensor Neutral Position was any paint work or repairs done to the front end?
no damage to the front
after this code is cleared there is a TCS Pressure Sensor Neutral Position Memorization that needs to be done. you can do this without the Honda test equipment by grounding terminal 9 at the DLC(brown wire) where is says to short the SCS. if this does not work the abs/TCS module needs replacement.