How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask HondaPlatinum Your Own Question
HondaPlatinum, A Technician
Category: Honda
Satisfied Customers: 25920
Experience:  13 year honda platinum level
Type Your Honda Question Here...
HondaPlatinum is online now
A new question is answered every 9 seconds

1997 Honda Accord EX 5 Speed clutch master & slave cylinders

Customer Question

1997 Honda Accord EX 5 Speed clutch master & slave cylinders replaced and now have no pressure at the clutch pedal. There are also no leaks, what am I overlooking ??
Submitted: 7 years ago.
Category: Honda
Expert:  HondaPlatinum replied 7 years ago.
Ok how did you bleed the system?
Customer: replied 7 years ago.

Put fluid in the master cylinder first and then the slave and put everything back together and then put fluid in the resovars. Start pumping clutch and trying to bleed cylinder but not getting any pressure.

Expert:  HondaPlatinum replied 7 years ago.
Ok you need to bleed the system correctly im posting the procedure.
Customer: replied 7 years ago.
Are you posting the procedure to my email or where can I get it ???
Expert:  HondaPlatinum replied 7 years ago.

1.Get a long rubber hose to fit snug over the bleeder valve on the slave cylinder

2.Submerge that hose in a new bottle of dot3 brake fluid .Put that bottle in a drain pain with the hose in it it can get messy.

3.Open the bleeder on the slave cylinder

4.Take another bottle of dot3 brake fluid and turn it upside down in the clutch master

5.Pump the clutch pedal by hand 5 to ten times always checking there is fluid in the master.You cna not let any air get intot the system so always check the master level while bleeding.Continue to pump the clutch pedal till you go through almost the whole bottle of break fluid.

6.Close bleeder at slave cylinder.

Should have a pedal now any little bit of air trapped will cause you to have no pedal very tempermental this system.

Customer: replied 5 years ago.
I am looking for the wiring diagram & wire colors for the original radio harness on this 1997 Honda Accord ES
Expert:  HondaPlatinum replied 5 years ago.
Radio Constant 12V+ Wire: Yellow/White
Radio Switched 12V+ Wire: White/Red
Radio Ground Wire: Black
Radio Illumination Wire: Red/Black
Radio Dimmer Wire: n/a
Radio Antenna Trigger Wire: Yellow/White
Radio Antenna Location: Left Rear
Front Speakers Size and Location: 5 1/4″ Doors
Left Front Speaker Wire (+): Blue/Green
Left Front Speaker Wire (-): Gray/Black
Right Front Speaker Wire (+): Red/Green
Right Front Speaker Wire (-): Brown/Black
Rear Speakers Size and Location: 6 1/2″ Rear Deck
Left Rear Speaker Wire (+): Blue/Yellow
Left Rear Speaker Wire (-): Gray/White
Right Rear Speaker Wire (+): Red/Yellow
Right Rear Speaker Wire (-): Brown/White