How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask t-fran21 Your Own Question

t-fran21
t-fran21,
Category: Honda
Satisfied Customers: 1538
10186415
Type Your Honda Question Here...
t-fran21 is online now
A new question is answered every 9 seconds

Remove the interior driver side door panel on a 1997 honda Accord?

Resolved Question:

How do I remove the interior driver side door panel on a 1997 honda Accord?
Submitted: 5 years ago.
Category: Honda
Expert:  t-fran21 replied 5 years ago.

good luck. and please accept my answer. thanks T-MAN

 

1mDoor Panel/Plastic Cover Replacement

  1. Remove the mirror mount cover panel. NOTE : Take care not to scratch the door panel and other parts.

  1. If applicable, remove the regulator handle by pulling the clip out with a wire hook.



NOTE: Install the regulator handle so it points forward and up at a 45 degree angle with the glass closed.

  1. Pry out the cap and remove the screw.

  1. Pull the inner handle forward and out half-way, and disconnect the inner handle rod and power door lock connector.

  1. Remove the armrest screw.

  1. Release the clips that hold the door panel. Remove the door panel by pulling it upward. NOTE : Remove the door panel with as little bending as possible to avoid creasing or breaking it.

  1. Disconnect the following:
    • Power window connectors
    • Power mirror connector (driver's)
    • Courtesy light connector

  1. Remove the bracket and power door lock control unit, and disconnect the connectors.

  1. Detach the grommets and harness clips, then carefully remove the plastic cover.

  1. Before installing the plastic cover, make sure the door harness and connectors are fastened correctly on the door.

  1. Install the plastic cover and all removed parts. NOTE ;
    • Apply adhesive along the edge where necessary to maintain a continuous seal and prevent water leaks.
    • Do not plug the elongated holes.
    • Sedan; To prevent contamination, cover the hole at location A with adhesive tape.
  1. Install the door panel. NOTE:
    • Make sure the door harness is not pinched.
    • If necessary, replace any damaged clips.
    • Make sure the connectors are connected properly.
  1. Instal) the armrest pocket (sedan/wagon, passenger's) and inner handle. NOTE : Make sure the connector is connected properly.
  2. If applicable, install the regulator handle.
  3. Install the mirror mount cover panel.
t-fran21,
Category: Honda
Satisfied Customers: 1538
Experience: 
t-fran21 and 5 other Honda Specialists are ready to help you

JustAnswer in the News:

 
 
 
Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.
 
 
 

What Customers are Saying:

 
 
 
  • Thank you very much for saving my daughter and her family a lot of money on her Honda. You are definitely on my list for future help. Thanks, again. Fred USA
< Last | Next >
  • Thank you very much for saving my daughter and her family a lot of money on her Honda. You are definitely on my list for future help. Thanks, again. Fred USA
  • I just heard from my mechanic. You were right...a $45.00 job. THANK YOU!! Your response was received in less than 10 minutes!! Linda B. USA
  • Your answers were clear and the diagrams were perfect. Dealer wanted $87 for an hour of labor and even I did it in 15 minutes. Ed USA
  • HONDA PLATINUM was great. I really appreciate his help. I was ready to trade my new Honda until he told me to wait until I got 3,000 miles on it and my gas mileage would get much better. Summer USA
  • I took the Power Steering O-Ring service bulletin linked from JustAnswer to my Acura dealer, and not only did they no-charge the o-ring, they also replaced the power steering pump at no cost. Gary R Stevenson Ranch, CA
  • Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help. Mary C. Freshfield, Liverpool, UK
  • This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!! Alex Los Angeles, CA
 
 
 

Meet The Experts:

 
 
 
  • Kyle N.

    Honda Master Tech

    Satisfied Customers:

    3627
    Honda Dealer Tech, ASE Master Auto Tech
< Last | Next >
  • http://ww2.justanswer.com/uploads/hondatech/2010-05-03_025935_resized_work_pic.jpg Kyle N.'s Avatar

    Kyle N.

    Honda Master Tech

    Satisfied Customers:

    3627
    Honda Dealer Tech, ASE Master Auto Tech
  • http://ww2.justanswer.com/uploads/hondacb77/2008-10-27_165606_me3.jpg John G.'s Avatar

    John G.

    Honda Technician

    Satisfied Customers:

    2643
    Dealership tech since 1982. ASE and Honda Master Technician.
  • http://ww2.justanswer.com/uploads/MU/muddyford/2012-6-13_1204_1.64x64.png Chris (aka-Moose)'s Avatar

    Chris (aka-Moose)

    Technician

    Satisfied Customers:

    204
    16 years of experience
  • http://ww2.justanswer.com/uploads/FO/fordguy4u/2011-12-17_222940_HPIM1257.64x64.JPG Ron's Avatar

    Ron

    ASE Certified Technician

    Satisfied Customers:

    175
    ASE Certified Tech 34 years.
  • http://ww2.justanswer.com/uploads/EU/eurotec/2012-6-11_13153_mpjaphoto.64x64.JPG Marty's Avatar

    Marty

    Bosch Master Tech

    Satisfied Customers:

    113
    Bosch Certified Master Technician
  • http://ww2.justanswer.com/uploads/AM/amedee/2013-10-24_23656_Amedee1.64x64.jpg Amedee's Avatar

    Amedee

    ASE Master Technician

    Satisfied Customers:

    1112
    ASE Master Technician advanced level specialist. Wisconsin certified emissions state inspector
  • http://ww2.justanswer.com/uploads/TH/thebesthonda/2011-1-15_04510_Photo022009005.64x64.jpg thebesthonda's Avatar

    thebesthonda

    ASE MasterTechnician

    Satisfied Customers:

    2299
    26 years experience
 
 
 
Chat Now With A Mechanic for Honda
t-fran21
t-fran21
Mechanic for Honda
1538 Satisfied Customers