Honda Repair Questions? Ask a Mechanic for Answers ASAP
Welcome to Just Answer!
Do you have the radio code card? Please let me know. Thank you.
You will need to turn the key to the on position. From there the radio should come up with code or something similar. You will enter the code from the card. Once that is done, the screen should turn on & you will need to reset all your radio presets, etc. Have you tried entering the code more than 3 times? If so you will have to disconnect your batter for approximately 10 minutes & retry the code again. Please let me know if that works. Thank you.
it didn't work
what i want to know how enter the code?
which bottom i have to use?
What do you mean by which bottom do you have to use? Please let me know. Thank you.
i have the code but i don't now how input it?
Do you have anything that has #'s 1-6 on it? Please let me know? Thank you.
I haven't forgotten you. I'm trying to find something for you, exactly. I will be right back. Thank you.
This is what I found & is this what you are getting or is the entire screen blank? Here it is:
Navigation System 63
If for any reason, you lose power to the
navigation system (like the battery was
disconnected), the navigation system
will require initialization. Once
completed, your system will be ready
This initialization requires the
security code to ‘‘unlock'' the
needed depending of the length of
time the system was without power).
coordinates to a place on the map.
Entering the Security Code
If the battery goes dead or is
disconnected for any reason, you will
have to enter a security code into both
the audio system and the navigation
system before you can use it again.
When you purchased the vehicle, you
should have received two cards that
have the audio and navigation system's
security codes and serial numbers.
Keep these cards in a safe place in case
you need the codes. If you lose the
cards, you must obtain the security
After the battery is reconnected, and
you turn the ignition switch on, the
software of the navigation system is
downloaded from the disc.
When downloading completes, you will
Enter the four-digit navigation system
security code, then select Done. If you
have entered it correctly, the display
changes to the Disclaimer screen. You
have ten chances to enter the correct
code. If all ten are incorrect, turn the
ignition to OFF, then back to ON (II) to
have ten more chances to enter the
Follow the instructions in the vehicle
owner's manual to enter the audio code.
The navigation voice will not operate if
the audio code is not entered.
codes from your dealer.
Let me know if you need any other help please. Thank you.
know how i need to enter the audio code that's my question?
Thanks for the help acura mstr, I did find the correct one I was looking for now. Here it is:
Should be page 19 of 28 or page 153.
Yes that's right now. Also have a link to Honda ownerlink, so you can register your vehicle & radio & navigation codes also. Here:
Please let me know if you have any other questions. Thank you.