How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Don 'Mo Lurch' Your Own Que...
Don 'Mo Lurch'
Don 'Mo Lurch', Auto Service Technician
Category: Honda
Satisfied Customers: 20437
Experience:  Aftermarket & Factory Mobile Electronics. Sales, Installation & Repair for 30 years. R/S, etc.
Type Your Honda Question Here...
Don 'Mo Lurch' is online now
A new question is answered every 9 seconds

How to remove and replace key ignition switch 1991 accord

This answer was rated:

key ignition switch is not working, some times must hold it to keep motor running!
  1. Disconnect the negative battery cable. If so equipped, disable the Supplemental Restraint System (SRS).

  2. On1990-93 Accords, remove the steering wheel.

  3. Remove the steering column covers.
  4. Unplug the ignition switch connector.

  5. Insert the key and turn it to the O position.

  6. If present, remove the tape on the switch wires. .

  7. Remove the two screws securing the switch, then remove the switch.

Click image to see an enlarged view
Fig. 1: The switch is secured by two screws

To install:

  1. Make certain the recess of the switch aligns with the tab of the lock housing. Insert the switch and install the retaining screws.

  2. If applicable, install the switch cover and retape the wires.

  3. Remove the key.

  4. Connect the wiring harness to the ignition switch.

  5. Reinstall the steering column covers.

  6. Install the steering wheel or any other applicable trim panels.

  7. If applicable, enable the SRS.

  8. Connect the negative battery cable.

Ignition Key Cylinder:

Remove ignition switch as described
Remove key light case from lock body, if equipped.
Place ignition lock in the I position.
Insert suitable punch into hole on lock cylinder housing and depress pin, then remove lock cylinder from housing.

Don 'Mo Lurch' and 5 other Honda Specialists are ready to help you
Customer: replied 9 years ago.
My problem is I can not see how to get the key cylinder out,There is white plastic cover with light, I can remove the light, but how get the plastic off and then I do not see a hole for the cylinder release pin.

Remove the Steering Column Shroud completely: