How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask ITPeter Your Own Question
ITPeter
ITPeter, Engineer
Category: Home Theater-Stereo
Satisfied Customers: 15763
Experience:  Electronic Engineer
30970729
Type Your Home Theater-Stereo Question Here...
ITPeter is online now
A new question is answered every 9 seconds

I have a denon AVR 1000 stereo I cannot get it out of

Customer Question

I have a denon AVR 1000 stereo I cannot get it out of protect mode
Submitted: 1 year ago.
Category: Home Theater-Stereo
Expert:  ITPeter replied 1 year ago.

Hi there,

Protect mode indicates that there is a fault with the speakers or the amplifier.

Try disconnecting the speakers, then turn the stereo on again.

If it is out of Protect mode then one or more of the speakers has a fault, or the speaker wiring was shorted out.

If it still shows Protect mode on the display then the built-in amplifier has a fault and it will require a repair.

Customer: replied 1 year ago.
I have already done that ! I also held the on switch with the tune switch simultaneously they said there was some kind of reset but I do not have my manual that's why I came to just ask
Expert:  ITPeter replied 1 year ago.

Hi,

The only reset you can try is to unplug the power supply for a few minutes and try again.

If the system still shows Protect mode when the speakers are disconnected then the internal amplifier is faulty and will need to be replaced.