Recent Feedback
Good day. I have nemtek stealth m25s energizer. The problem is that we put it on and in about 15-20mins it sounds an alarm. Once we reset it it shows fence good and then within about 30 secs it flashes check and another 30 secs later it flashes alarm then goes back to flashing good. Then in about 20mins the alarm sounds. only to repeat the whole cycle again. the wires have now been replaced, the energiser tested and serviced and there are no wires off or problems on the fence. please help!
Already Tried: replaced earth and live wires on fence and energiser, replaced links and other possible connections which could be faulty
Hi With the fence on and in alarm take a walk around the fence and listen for any shorts...
You are about to be introduced to our rating system. Please rate my answer, not the website or the news in my answer. Your deposit means you have been charged. You now get to decide to pay me (from that deposit) the assisting tech or leave that money in your account here.
Bad or Poor service----Does not pay me, and means you had a negative experience
OK or Good or Excellent service---Pays me and means you had a positive experience
If you need to reply, please do so. Do not rate, press Reply to Expert.
Hi again. Thanks for this. I tried this and it does not seem to be the problem, what now?
Next step is to measure the actual fence voltage... It could be there is a fault with the units voltage sensing circuitry causing it to think it is in alarm when it isn't... The best way to confirm this is to see what the voltage is when it is in alarm, but you will need an electric fence voltmeter...http://www.ebay.com/itm/Digital-Voltmeter-for-Electric-Fence-/310125948250?pt=LH_DefaultDomain_0&hash=item4834f26d5a#ht_500wt_715You should be able to get a similar type of meter in South Africa..