How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Machinc Your Own Question
Machinc
Machinc, General Contractor
Category: Home Improvement
Satisfied Customers: 868
Experience:  Has written home improvement articles since 2008. Earned South Carolina Residential Builders License in 1991.
75209918
Type Your Home Improvement Question Here...
Machinc is online now
A new question is answered every 9 seconds

I have finished mounting my HD220 garage door opener, I can

Customer Question

I have finished mounting my HD220 garage door opener, I can move the door with the
controls on the backside of the opener but I can't program the door the for the opener switch, when I try to set the program for the close position the door gets to the close
position & immediately begins to go to the rise to the open movement
Submitted: 1 year ago.
Category: Home Improvement
Expert:  Machinc replied 1 year ago.

It sounds like the safety sensors arent lined up properly

or not wired . They should face each other with an uninterupted line of sight.

If they are lined up and still not working check the wiring. Check for loose connections. There other possibilities but these are the most common. If this does not fix the problem check the control board . I will be glad to answer any questions you may have.

Expert:  Machinc replied 1 year ago.

The control board could be bad but it is not likely for a new one. Check the wire connections on the board and its power connections.

Related Home Improvement Questions