How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Jon K. Your Own Question
Jon K.
Jon K., Small Engine Diagnostic Expert
Category: Home Improvement
Satisfied Customers: 5818
Experience:  Gold certified Stihl tech, Service Manager for a rental/repair shop.Certified in most small engines
Type Your Home Improvement Question Here...
Jon K. is online now
A new question is answered every 9 seconds

How to remove blade on [email protected] cat. # XXXXX type 1 electric mower,

Customer Question

How to remove blade on [email protected] cat. # XXXXX type 1 electric mower, 18" cut. The blade is spinning freely and shaft turns when I turn the nut.
Submitted: 4 years ago.
Category: Home Improvement
Expert:  Rick replied 4 years ago.

repairguy :

my name is Rick ,I will assist you

repairguy :

You are going to need a pipe wrench, so you can stop the shaft from spinning.

Customer: replied 4 years ago.

There is less than one eighth inch under blade to the iron housing. No tool will fit as with gas engine shafts.

Expert:  Jon K. replied 4 years ago.
The only way I have found to remove the blades on these electric motors is to use an impact gun. If you have one or have access to one be very careful installing it after you have sharpened or replace it. The square plastic spacer that goes between the blade and the nut must be set in place perfectly (there are two tabs that go over the blade and an oblong hole that fits the blade hub)
My suggestion to you is to bring it to a shop. Most shops will remove or install a blade for free or very little. If you are looking to sharpen the blade they will do that as well again for a minimal charge

Related Home Improvement Questions