have a sears opener.opened ,pulled truck out,went back in house ,door would not shut.no response ,no lights any where on opener. plug is hot. opener one half horse two yrs old.acts like gettin no power but like i said a/c plug is good.whats up?
checked for power at plug,ok. opened panel where logic board is,couldnt tell anything.logic boaed is 110,but dont know if thats it
Hi and thanks for choosing JustAnswer.com. Most likely something has bumped the sensor(s) out of alignment, or obstructed communication between the sensors. In that state remotes will not close the door. You can override the safety system by holding the wall button down. Tell me what happens when you hold the wall button down.
35 years of troubleshooting construction, remodel, component & material failures. What to do next
I trust you discovered something amiss with the sensors. Thank you for your favorable rating, and thank you for choosing JustAnswer.comNo need to reply unless you need further assistance.