I need help. I have a 2003 kw t2000 with a cummins isx engine. I was replacing my starter with a denso starter and i may have connected a hot wire that was on my old silaoid to the ground. There in only one small connecter on the new one. Anyway when i connected my batteries and tried to start truck all lights in cab and on dash came on as usual. But when i turn the key to crank engine i lost all power. Now i have nothing. Any help? I checked fuses on passesger side under glove box is there anymore that i dont know about?
Engine: cummins isx
Hello and welcome to Just Answer! I would be more than happy to assist you today.Yes there are 2 fuses in the battery box as well as on the engine harness that should be checked. The fuses in the batt box are for engine computer only.
where is the engine harness that has the fuses?
attached to the engine..... You will see a fuse holder by the ecm.. Also attached to the engine
there is a box with a plastic cover on it. i took cover off there is cable and nut attached to one side. another attached to othere side is that a fuse of some type in the center? also, i only see one fuse in battery box.
Relist: Other.I need to know what to do to get power back to my truck
Ok since you are unable to locate fuses. we will try another way.. are you getting a check engine and stop engine light on the dash that comes on and goes off when key is in the on position.
there is nothing that comes on....no power. not even dome light
Hi I'm Wayne, I will help you with this,Good Morning In the middle of the firewall (engine side)There is a cluster of wires, in a tape/thread harness, need to open this up cut that very careful with razor, not to cut any wires once open you will find a 10 Ga wire with fueable link, the powers the cab
are you talking about the clusters on pass side that go toward fuse panel there are four dif. clusters that plug into sockets are these what your talking about? if so which one?
HiNo in the middle of fire wall willl be like 3 of them 2 smaller 1 bigger one Wayne
34 years experiance as engine rebuild and problems.Thermo-King repair and trouble shooting.
thank you wayne. you did help. i am sorry i thought i had hit accept but i must not have.