Recent Feedback
Hello, going back to my other post about adjusting the clutch pedal you mention to press the pedal but not all the way to the floor just like to know the why and how far down needs to press to adjust it Thank you.
Optional Information: Make: KW Model: T2000 Year: 2002 Engine: N14
Hi I'm Wayne, I will help you with this,Good Morning You want it about 1 1/2 off the floorreason being, if you put it all the way to floor, the T/O bearing will be against the clutch break, and you will not get the correct adjustment on brake
Little confused here to find out the adjuster bolt is this inside bellhousing driver side? I can reach a bolt head right by the fork arm is this the bolt you mention? Sorry.
HiNo it is not inside , the bolt you are touching on the fork is for the forkto remove/replace it If you don't see it under there , look in cab at the top of the pedal Wayne
Ok found it was in the top of pedal, now to bring the pedal up do I go right or left on adjuster thanks.
Hi You want to bring the pedal up , more travelWaynewayne41069.6495808681
Ok I turn the nut and bolt are loose the pedal arm has a cross bar going tru it how do I loose the to Make it spin and bring pedal up hiope I Make sense
HiGet a pair of vise grips, or pipe wrench to turn the barIt just come to me , Normally when clutch is adjusted, the clutch brake is adjust at same time, I am wondering if the clutch brake is worn out this is why it is not grabbing With pedal all the way to floor, is Brake touching the T/O bearing
Well with the pedal all the way to the floor it Almost reaches but not quiet brake is there is about a 1/4 " thick I don't know if should be thicker any clues Thank you.
OK, That is good brake so do the pedal like I suggested
Experience: 34 years experiance as engine rebuild and problems.Thermo-King repair and trouble shooting.