How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tim Your Own Question
Tim
Tim, Foreman
Category: Heavy Equipment
Satisfied Customers: 356
Experience:  23 Years Heavy Equipment and Truck Repairs Shop and Field in the Minning and Construction Industry
16986108
Type Your Heavy Equipment Question Here...
Tim is online now
A new question is answered every 9 seconds

Diagram for serpentine belt routing on 2006 c15 twin turbo engine

Customer Question

need diagram for serpentine belt routing on 2006 c15 twin turbo engine
Submitted: 7 years ago.
Category: Heavy Equipment
Expert:  Tim replied 7 years ago.

Hello, Welcome to JA, my name isXXXXX will try to help.. I have tried to find a diagram before on these with no luck.. the last time a question came up here on JA I looked at one of my 2006 c15 and wrote it out.. see if this will help before you decide to accept

 

 

ours has 2 belts

 

the 8 rib belt

 

off top of fan hub inner grooves.. towards pass side.. under statinary idler pulley..over alternator pulley... down and around lower stationary idler...up over tensioner pulley..down under dampner pulley ... back up to fan..

 

 

the 6 rib belt

 

around fan outer grooves up to a/c compressor.. tensioner sits against belt

 

 

See if this will work for your application, before you decide to accept....mine is for a KW so it may not.. I tried everthing to get a picture with no luck..from Cat and from KW.. you may get lucky with INT. service dept.

 

Tim

 

 

 

Customer: replied 7 years ago.

THANKS, XXXXX XXXXX THE ROUTE THAT THE BELTS GO, BUT YOU WERE ABOUT AN HOUR LATE. I WILL ACCEPT ANYWAY, BECAUSE I MAY NEED YOUR HELP AGAIN.

 

THANKS AGAIN

 

ART

Expert:  Tim replied 7 years ago.

Hello, I am sorry so late.. .. I just came back on a few minutes ago, if it didnt help.. no need to accept!!

 

Tim

Related Heavy Equipment Questions