What are torque specs for series 60 Detroit?
Optional Information: 1993 Kenworth Detroit SeriesmAlready Tried: Need torque specs for all bolts in 1993 series 60 Detroit
I have the manual on that engine but before I post I need the model number off the rocker cover to give accurate information, should be like a 6067gk or wk.
The 60 ser manual listed torque for nuts and bolts that are an exception to standard torque, meaning iuf not listed then use standard torque, I'll list a link at the end.
All in ft lbs. unless noted.
Main bearing cap: 347-391
flywheel housing: 118-148
connecting rod nut: 118-137
camshaft bearing cap bolt: 93-108
rocker arm shaft bolt: 100
1 & 7 camshaft studs and nuts: 93-108
camshaft drive gear bolt: 55 +120 degrees
flywheel bolts: 55 +60 degrees
injector hold down: 43-49
cylinder head bolt prior to 2002: 184-210
cylinder head bolt after 2002: 220
use the date on the rocker cover
after 2002 will have a groove on the head or white paint
rocker cover(1piece) 15-18
rocker cover (2 & 3 piece) 22-28
Cylinder head bolts must be coated on the threads and bolt to head contact area with international compound #2, more commonly called peanut butter from the Detroit dealer.
sequence in rows starting from passenger side of the engine front corner
The rest are standard on the chart from this link, be sure to coat all threads and head with oil except the head bolts as stated above.
Post back if you need further assistance.