GM Repair Problems? Ask GM Repair Expert Now.
MULTIFUNCTION, TURN SIGNAL SWITCH REPLACEMENT REMOVAL PROCEDURE
Attachments are only available to registered users.
CAUTION: Refer to SIR Caution in Service Precautions.
IMPORTANT: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes.
NOTE: Refer to Fastener Notice in Service Precautions.IMPORTANT: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.Tighten
IMPORTANT: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The ignition lock cylinder case wires and connector must be hanging out of the middle of the abrasion sleeve.