how to reset the theft deterrent system on 2003 hummer h-2
Optional Information: Year: 2003 Make: Hummer Make (other): gmc Model: h-2 Already Tried: we replaced the shift interlock sylinode switch by the key ignition and now the theft deterrent light is on and we need to know how to reset.
Unlock Doors with Remote or Key
Be sure the Battery is fully charged;
1. Turn ON the ignition, with the engine OFF. 2. Attempt to start the engine, then release the key to ON, vehicle will not start. 3. Observe the SECURITY telltale light, after approximately 10 minutes the telltale will turn OFF. 4. Turn OFF the ignition, and wait 5 seconds . 5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes , the vehicle is now ready to relearn the Passlock(TM) Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.IMPORTANT: The vehicle learns the Passlock(TM) Sensor Data Code and/or password XXXXX the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.6. Start the engine. The vehicle has now learned the Passlock(TM) Sensor Data Code and/or password. With a scan tool clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles.
the light never turned off and we tried the ten min. intervales as said in the answer. the car still will not start
That is the reset & programming........
You have either broken a wire, disconnected something or caused a short to the BCMYou will need use of Dealer Scan Tool to test the PassLock Circuit & Modules, as there is no way for anyone to tell what has been done to the System without testing DATA via Dealer Scan Tool