How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask MPMoore Your Own Question
MPMoore
MPMoore, GM WORLD CLASS/ASE MASTER W/L1 GMC
Category: GM
Satisfied Customers: 2956
Experience:  15 YEARS AS GM TECH, TEAM LEADER/SHOP FOREMAN AT A GMC DEALERSHIP
4232346
Type Your GM Question Here...
MPMoore is online now
A new question is answered every 9 seconds

2000 yukon denali: diagram of how to replace the ignition switch

Resolved Question:

i need a diagram of how to replace the ignition switch 2000 yukon denali you told me i need and paid
Submitted: 7 years ago.
Category: GM
Expert:  MPMoore replied 7 years ago.
To replace the switch, you need to remove the trim bezels around the steering column.


Object Number: 280860  Size: SH
Pull the tilt steering column lever (1) out from the steering column (2).


Object Number: 415298  Size: SH



Object Number: 415299  Size: SH

  1. Disconnect the steering column electrical connectors.

  2. Object Number: 322946  Size: SH
Object Number: 306234  Size: SH

  1. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).

  2. Object Number: 306267  Size: SH






























Expert:  MPMoore replied 7 years ago.
Had to stop and use another window to complete this diagram.


  1. Remove the key alarm connector (1) from the lock module assembly (2).
  2. 8.1. Rotate the key alarm connector (1) 90 degrees.
    8.2. Pull the key alarm connector (1) out of the lock module assembly (2).

    Object Number: 306272  Size: SH



Remove the last 2 screws on the switch and then install new switch.
MPMoore and other GM Specialists are ready to help you