How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask jazzmaster Your Own Question
jazzmaster, ASE Certified Tech
Category: GM
Satisfied Customers: 2951
Experience:  ase certified--32 yrs experience
Type Your GM Question Here...
jazzmaster is online now
A new question is answered every 9 seconds

2005 Dodge Durango: I reset the ABS light..scanner

Resolved Question:

I have a 2005 Dodge Durango. How do I reset the ABS light? I have a scanner, but the scanner will not clear it.
Submitted: 6 years ago.
Category: GM
Expert:  jazzmaster replied 6 years ago.
you need a good scanner to clear these codes not just a cheaper one,,and if it does not clear then there still is something that is still putting the code(s) back in ....guy..
jazzmaster and other GM Specialists are ready to help you
Customer: replied 6 years ago.
What is P0581 code?
Customer: replied 6 years ago.
the p0581 code says cruise control multi funct input A ckt high what or where is this ?
Expert:  jazzmaster replied 6 years ago.

hi ,that is a speed control code ,the most likely cause is the clockspring in the column,if your cruise control does not work or does not work right,also it could be a dirty switch in the steering wheel ,..guy..graphic

With the ignition key on.

Speed control switch input above the maximum acceptable voltage at the PCM. One trip fault.


  • (V37) S/C Switch NO.1 signal circuit shorted to battery voltage
  • (V37) S/C Switch NO.1 signal circuit open
  • (V937) Switch return circuit open
  • Clockspring
  • Speed control switch
  • PCM

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.



NOTE: Do not press any of the Speed Control Switch buttons.

Ignition on, engine not running.
With a scan tool, read the Speed Control voltage.

Q: Is the Speed Control voltage above 4.8 volts?

YES: Go To 2
NO: Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Perform the POWERTRAIN VERIFICATION TEST. See: Verification Tests\Powertrain Verification Test

Turn the ignition off.
Remove and disconnect the Speed Control Switches from the steering wheel.
Measure the resistance across each Speed Control Switch.
Monitor the ohmmeter while pressing each function button on each switch.
The following resistance specs are taken between terminals (V37) S/C Switch No.1 Signal and (V937) S/C Switch Return circuits of the Switch when holding the switch button in the following position Not pressing any
switch - 20.5 kohms
On/Off - 0.47 kohms
Set - 5.49 kohms
Coast -2.94 kohms
Cancel - 1.24 kohms
Resume/Accel - 15.4 kohms

jazzmaster and other GM Specialists are ready to help you

Related GM Questions