How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask car tech Your Own Question
car tech
car tech, ASE Certified Technician
Category: GM
Satisfied Customers: 3332
Experience:  25 year master tech and shop owner
1511099
Type Your GM Question Here...
car tech is online now
A new question is answered every 9 seconds

2008 hhr remote lock unlock fob, how to program??

Customer Question

2008 hhr remote lock unlock fob, how to program??
Submitted: 6 years ago.
Category: GM
Expert:  car tech replied 6 years ago.
Remote Control Door Lock Transmitter Programming

Important:

Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle. The order in which the transmitters are programmed is important. The first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. Use care to program the transmitters correctly.
The scan tool must stay connected until all of the transmitters are programmed.
The keyless entry transmitters used in the Advance 2 Way Remote Start System isare unique to the system. When servicing or replacing a transmitter, ensure that the correct transmitter is used. The correct transmitter part number can be found in the Accessory section of the parts catalog. Attempting to replace an Advance 2 Way Remote Start transmitter with a regular service part will result in a failure to program the transmitter.

 

Invalidate All

This procedure will erase all keyless entry transmitters from memory.

  1. Install a scan tool.
  2. Turn ON the ignition with the engine OFF.
  3. With the scan tool, select Body.
  4. Select Remote Control Door Lock Receiver (RCDLR).
  5. Select Module Setup.
  6. Select Program Key Fobs.
  7. Select Invalidate All.
  8. Follow the scan tool on screen instructions.

Next Available Slot

Incremental programming allows for a transmitter to be programmed into the next available location without affecting the currently programmed transmitters. Previously programmed transmitters will not be erased during this procedure.

Important: If all 4 slots are programmed, the Invalidate All procedure will need to be performed to allow transmitter programming.

  1. Install a scan tool.
  2. Turn ON the ignition with the engine OFF.
  3. With the scan tool, select Body.
  4. Select Remote Control Door Lock Receiver (RCDLR).
  5. Select Module Setup.
  6. Select Program Key Fobs.
  7. Select Next Available Slot.
  8. Follow the scan tool on screen instructions.
  9. Remove the scan tool.
  10. Exit the vehicle. Operate all functions on transmitters to verify correct system operation.

Transmitter Slot Programming

Transmitter slot programming allows a single transmitter to be programmed into a specific slot without affecting any of the other programmed transmitters. By using slot programming, the transmitter originally programmed to a specific slot is erased and the new transmitter learned in its placed.

  1. Install a scan tool.
  2. Turn ON the ignition with the engine OFF.
  3. With the scan tool, select Body.
  4. Select Remote Control Door Lock Receiver (RCDLR).
  5. Select Module Setup.
  6. Select Program Key Fobs.
  7. Select the key fob desired to be programmed.
  8. Follow the scan tool on screen instructions.
  9. Remove the scan tool.
  10. Exit the vehicle. Operate all functions on transmitters to verify correct system operation.