How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ivan Your Own Question
Ivan
Ivan, ASE Certified Master Technician
Category: GM
Satisfied Customers: 4871
Experience:  ASE Master Tech.20+ years exp. 9 years self employed. Participant on AutoLab Radio broadcast
10772012
Type Your GM Question Here...
Ivan is online now
A new question is answered every 9 seconds

How to remove and replace a serpentine belt on a 03 envoy

Resolved Question:

how to remove and replace a serpentine belt on a '03 envoy
Submitted: 7 years ago.
Category: GM
Expert:  Ivan replied 7 years ago.

Hello Les, Look at the procedure below. The belt wraps around the fan clutch pulley, so nothing needs to be disconnected to get it out. That loop just needs to be raised to get the belt out of that side of the engine.

 

Your JA Expert,

Ivan

 

Drive Belt Replacement

Removal Procedure

  1. Install 3/3 inch breaker bar on the drive belt tensioner arm and turn the breaker bar clockwise enough to relieve the tension on the drivebelt.
  2. Remove the drivebelt.
  3. Release the tension on the tensioner arm.

Installation Procedure

  1. Route the drivebelt over all the pulleys except the drivebelt tensioner pulley.
  2. Install the 3/8 inch breaker bar on the drivebelt tensioner arm and turn the breaker bar clockwise.
  3. Install the drivebelt over the drivebelt tensioner pulley.
  4. Slowly release the tension to the drivebelt tensioner arm.
  5. Inspect for proper installation of the drivebelt on the pulleys.
Ivan and 3 other GM Specialists are ready to help you