How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ellen Your Own Question
Ellen
Ellen, Consultant
Category: General
Satisfied Customers: 109
Experience:  attorney and legal researcher
9968427
Type Your Question Here...
Ellen is online now
A new question is answered every 9 seconds

How do I install the new belt ECR-330D?I have pulled

Customer Question

How do I install the new belt for my ECR-330D?I have pulled out the insides so I can get to it, but don't know where to start.
Submitted: 1 year ago.
Category: General
Expert:  BestOne1943 replied 1 year ago.
I don't know what brand you ECR330d is, but if you have a 1/8th" toothed belt for turning the detail, most of these Epson printers have a drive gear that has a small latch right next to the center of the gear. There is also a link that feeds the ribbon. This gear will slide off the shaft to allow the belt to be place over the shaft and gear. The gear is also splined to fit the shaft in only one position. It must go back in that POSITION TO WORK.Does this sound like your register?