How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Your Own Question
Ron
Ron, ASE Certified Technician
Category: Ford
Satisfied Customers: 23001
Experience:  23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs
7276279
Type Your Ford Question Here...
Ron is online now
A new question is answered every 9 seconds

Have 2000 f250 diesel have a squealing noise when in gear

Customer Question

have 2000 f250 diesel have a squealing noise when in gear and let off the accelarator, manual transmission
JA: Have you heard this particular sound before?
Customer: no
JA: Are you fixing your F250 yourself? What have you tried so far?
Customer: no taken to mechanic yet
JA: Anything else you want the mechanic to know before I connect you?
Customer: replaced flywheel about 6 months ago
Submitted: 2 months ago.
Category: Ford
Expert:  Chad Farhat replied 2 months ago.

Hi, I'm Chad. Welcome to JustAnswer. I'm reviewing your question and I will be posting your reply ASAP.

Expert:  Chad Farhat replied 2 months ago.

hey how are you

1- has clutch & pressure plate kit been replaced when flywheel replaced ?

2-sound like throw out bearings noise

3- warped flywheel, but u replaced ,unless went bad again , but usual will have rough idle if warped

4- what is the mileage on truck

Please let me know

Thank You

Chad Farhat

ASE Certified Technician

Customer: replied 2 months ago.
220000, clutch has been replaced, no sound heard when idling, other than slight rattle
Customer: replied 2 months ago.
squeal heard when changing gears, mainly from 3rd gear up, not in low gears
Expert:  Chad Farhat replied 2 months ago.

is easy to engage in gear ?

unless the syncro in the trans is wearing out , how is the truck used , pulling or daily driver ?

Customer: replied 2 months ago.
very easy to engage gear, mainly daily driver
Expert:  Chad Farhat replied 2 months ago.

you will have to start with the clutch, pressure plate , throw out bearing inspection and go from there

i guess raising on lift and using a ear scope and listen will be best to confirm it for you , but i can hear it :)

Expert:  Chad Farhat replied 2 months ago.

how many miles on clutch since replacement ?

Customer: replied 2 months ago.
less than 20K
Customer: replied 2 months ago.
if throw out bearing, would it not also do it in low gears?
Expert:  Chad Farhat replied 2 months ago.

yes should do in all gears , now it might be more evident in higher gears since less engine noise

not sure on this you will have to inspect it .

Related Ford Questions