How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, ASE Certified Technician
Category: Ford
Satisfied Customers: 21599
Experience:  ASE Master and Advanced level certified. Factory trained with 15 years dealership experience
9825021
Type Your Ford Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

Ok i got a po320 and checked all the wires and they look

Customer Question

ok i got a po320 and checked all the wires and they look good so i changed the ckp. and so far she is running good right now.
JA: Have you checked all the fuses? Do you have a wiring diagram?
Customer: no sir i dont
JA: What is the model/year of your Ford?
Customer: 96 ford bronco 302 stanard
JA: What year is your Bronco?
Customer: 1996
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: i have done a full tune up. changed the icm and just changed the ckp
JA: Anything else you think the mechanic should know?
Customer: no maam
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Ford Mechanic about your situation and then connect you two.
Submitted: 5 months ago.
Category: Ford
Expert:  john -aka eauto replied 5 months ago.

so what can i help you with ?

Expert:  sprinkles08 replied 5 months ago.

Hello and welcome to Justanswer!

It looks as though you were just looking for confirmation that the crank sensor shoudl take care of the P0320?

P0320 sets when the engine controller sees no input from the crank sensor but knows the engine is turning. Possible causes for a P0320 would be the crank sensor, it's connections and wiring, or it can also set if the cam sensor fails and produces a signal when the engine isn't turning (very rare). If you didn't see any wiring or connection issues with the crank sensor then replacing the sensor should take care of the code.