How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Your Own Question
Ron
Ron, ASE Certified Technician
Category: Ford
Satisfied Customers: 23001
Experience:  23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs
7276279
Type Your Ford Question Here...
Ron is online now
A new question is answered every 9 seconds

My 94 ford ranger, stopped on the way to work and now wont

Customer Question

my 94 ford ranger, stopped on the way to work and now wont start, i've relaced the coil distributor cap and rotor and the icm, i dont know what else to check
Submitted: 11 months ago.
Category: Ford
Expert:  AZTechBrian replied 11 months ago.

Have you tried to get it to start with starting fluid?

Customer: replied 11 months ago.
no, its got fuel pressure, when i crank it, i see maby 1 spark then thats all
Customer: replied 11 months ago.
it doesnt seem to have fire
Expert:  AZTechBrian replied 11 months ago.

There is a TSB for the ignition control module connector. Does the connector look good?

Customer: replied 11 months ago.
i took the old one to autozone and it failed the test and put on the new one with no result
Customer: replied 11 months ago.
tsb?
Expert:  AZTechBrian replied 11 months ago.

technical service bulletin. I don't suppose you have been able to check for codes?

Customer: replied 11 months ago.
no
Expert:  AZTechBrian replied 11 months ago.

I am wondering if the ignition pickup is faulty.

Customer: replied 11 months ago.
thats the one thing i havent replaced
Customer: replied 11 months ago.
could the icm and pick up both fail at the same time?
Expert:  AZTechBrian replied 11 months ago.

I imagine it's possible. was the control module verified to have failed?

Customer: replied 11 months ago.
it failed the test 3 times
Expert:  AZTechBrian replied 11 months ago.

Let me get you the instructions to try and adjust the ignition pickup.. one second

Expert:  AZTechBrian replied 11 months ago.

This is about all that's left that I can think of off the top of my head. In these situations, we usually just replace the distributor as a whole.

https://www.dropbox.com/s/vpn3qf7ux70rnlm/HES.jpg?dl=0

Customer: replied 11 months ago.
ok
Expert:  AZTechBrian replied 11 months ago.

check that stuff out and let me know how it goes. I am going to leave this open until I hear back from you.

Customer: replied 11 months ago.
ok thanks ill be back later
Expert:  AZTechBrian replied 11 months ago.

Ok. If I don't reply right away, I will as soon as I get the message. Sorry I wasn't able to give you a call. If someone comes along that's able to, they will give you a phone call.

Related Ford Questions