How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chris (aka- Moose) Your Own Question
Chris (aka- Moose)
Chris (aka- Moose), Technician
Category: Ford
Satisfied Customers: 43962
Experience:  16 years experience
Type Your Ford Question Here...
Chris (aka- Moose) is online now
A new question is answered every 9 seconds

05 ford e 350 van code p061b, 2105 and 2106, stalls wole d

Customer Question

05 ford e 350 van code p061b, 2105 and 2106, stalls wole driving
Submitted: 4 years ago.
Category: Ford
Expert:  Chris (aka- Moose) replied 4 years ago.

Hello, I'm Chris.
I will do my best to answer your question fast and accurate using the info you have provided. Thanks for visiting Just Answer.


For these codes you need to disconnect the negative battery cable and replace the electronic throttle body, which is mounted to the top of the intake manifold.

Customer: replied 4 years ago.
how do you verafie that
Expert:  Chris (aka- Moose) replied 4 years ago.
You verify that with the codes. All three codes are for the ETB and the ETB also controls the air coming into the engine and when the ETB fails the vehicle will stall.
Chris (aka- Moose) and 4 other Ford Specialists are ready to help you
Customer: replied 4 years ago.
chris the throttle body was changed by another tech, new part from ford
Expert:  Chris (aka- Moose) replied 4 years ago.

When was this done and were the codes erased after or during the replacement?


Customer: replied 4 years ago.
just done last week, i cleared code after replacing crank sensor
Customer: replied 4 years ago.
Relist: Inaccurate answer.
i have an 05 ford e-350 ford van, van stalls wile driving, replaced crank sensor, last week another tech reolace the electronic throttle control with a new ford part, same codes came back and van stalled
Customer: replied 4 years ago.
i forgot to put codes down p061b, p2105 and p2106
Expert:  Chris (aka- Moose) replied 4 years ago.

This can only leave a fault in the wire harness then. You can do the test I did which is 1-2-9 shown below.


Make sure no pins are damaged at the electronic throttle control connector and go through the harness back to the PCM to check for wire damage.

Customer: replied 4 years ago.
i can not down load the file you sent me, is it on my aldata ?
Expert:  Chris (aka- Moose) replied 4 years ago.

The file times out after 7 days and erases.

Here is a new file, yes if you dig through all data you can probably find a test like this maybe just written different.

Customer: replied 4 years ago.
thanks i will get to work on that, have you heard of this problem befor ?
Expert:  Chris (aka- Moose) replied 4 years ago.
Yes I see alot of ETB codes on vehicles, often its just the ETB at fault but not apparent in your case.

Related Ford Questions