How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Z. Your Own Question
Ron Z.
Ron Z., - Ford Tech -
Category: Ford
Satisfied Customers: 18456
Experience:  18+yrs experience. State Inspector & Ford Diagnostics/Repair
18617752
Type Your Ford Question Here...
Ron Z. is online now
A new question is answered every 9 seconds

Ford Fusion SEL how to replace low bean head light bulb on

This answer was rated:

how to replace low bean head light bulb on 2008 ford fusion, passenger side.

 

Low beam bulb

  • With the vehicle in NEUTRAL, position it on a hoist. graphic
  • Remove the screw and the fender splash shield access cover.
  • Remove the headlamp bulb protective cover. graphic

  • Remove the headlamp bulb.
  • Disconnect the electrical connector.
Ron Z. and 4 other Ford Specialists are ready to help you
Customer: replied 6 years ago.
found inner head light housing loose as i touched bulb connector, what would it take to remove head light housing assenbly

Headlamp Assembly (Driver's side shown, Passenger's side similar)

  • With the vehicle in NEUTRAL, position it on a hoist. graphic
  • Remove the 6 pin-type retainers (3 each side).
  • Remove the 8 fender splash shield screws (4 each side).
  • Remove the 4 air deflector bolts.
  • Remove the 2 bolts and the 2 pin-type retainers from the top of the radiator grille.graphic
  • If equipped, disconnect the fog lamp electrical connectors.
  • Remove the front bumper cover.
  • Remove the headlamp assembly pin-type retainer.graphic
  • Remove the 4 bolts and the headlamp assembly.
  • Disconnect the electrical connectors.