How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Your Own Question
Ron
Ron, ASE Certified Technician
Category: Ford
Satisfied Customers: 35061
Experience:  23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs
7276279
Type Your Ford Question Here...
Ron is online now
A new question is answered every 9 seconds

1993 ford: Batteries..starter..No crank no power on the dash.

Customer Question

I have a 1993 ford supreme E-350 mini bus. Batteries are charged, I get power to the starter but nothing on the ignition. No crank no power on the dash. Is there a ignition fuse that I can check and where is it located.
Submitted: 6 years ago.
Category: Ford
Expert:  Ron replied 6 years ago.
Chat Conversation Started
Ron :

Hello

Ron :

Your 1993 ignition switch is powered up on the yellow feed wire from the #8 60 amp fuse in the under hood fuse panel, start wth checking to see if its blown.

Ron :

The switch is the part you pull out to turn on the lights.


  • Disable airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.

  • Disconnect battery ground cable.

  • Insert a hooked tool into headlight switch knob slot and remove spring tension on knob, then pull off.

  • Remove headlamp auto dimmer switch knob, if equipped.

  • Remove righthand and lefthand moldings from instrument panel by pulling away from instrument panel and snapping out of retainers.

  • Remove 12 finish panel retaining screws.

  • Remove finish panel, then the headlamp switch bracket retaining screws and bracket.

  • Remove switch to bracket retaining nut, then disconnect electrical connector and remove switch.

  • Reverse procedure to install. Rearm airbag as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING


    Instructions HERE
  • Expert:  Ron replied 6 years ago.

    Disreguard the instruction listed , this was meant to go to another answer but was a glitch, just check the 60 amp fuse and let me know, we can go from there.



    Edited by Ron on 6/27/2010 at 6:26 PM EST