How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask AMEDEE Your Own Question
Category: Ford
Satisfied Customers: 24101
Experience:  ASE CERTIFIED TECHNICIAN ADVANCED LEVEL SPECIALIST. Wisconsin certified emissions state inspector
Type Your Ford Question Here...
AMEDEE is online now
A new question is answered every 9 seconds

Ford ranger: running rough..accelerate..30 miles..park and cool down

Resolved Question:

Ford ranger 3.0 running rough when you accelerate like out of time but clears up later down the road in 20 - 30 miles then runs fine until park and cool down then starts all over again and changed coil as well still no resolution
Submitted: 6 years ago.
Category: Ford
Expert:  AMEDEE replied 6 years ago.

Thank you for asking your question on Just Answer!
You could have a bad mass air flow sensor. Or the snorkel from the mass air flow sensor to the throttle body could be ripped. Both are very common and can cause you vehicle to loose power along with many other drive ability issues. First look for cracks or rips or anywhere air can enter the engine that is not accounted for by the mass air flow sensor. Next comes the Mass Air Flow (MAF) sensor. This is a very important sensor input to the computer. It uses a hot wire sensing element to measure the amount of air entering the engine. The MAF sensor then outputs an analog voltage signal to the PCM proportional to the intake air mass. The PCM calculates the required fuel injector pulse width in order to provide the desired air/fuel ratio. If the sensor is bad than this air/fuel ratio will be off causing severe performance issues. In extreme cases, I have seen these two problems cause a no start condition. This input can also be used in determining transmission Electronic Pressure Control, shift and torque converter clutch scheduling. The check engine light may even pop on if the sensor is bad, the snorkel is ripped or a tube has fallen off. This will result in a lean condition.
AMEDEE and 2 other Ford Specialists are ready to help you