Here are the instructions for the front door panels

1.Remove the 2 front door trim panel lower screws

2.Remove the door handle cover plate

3.Remove the pull cup screw cover

4.Remove the pull cup screw

5.Remove the window control switch

6.Remove the door handle screw

7.

NOTICE: Do not pull directly outward on the front door trim panel, as damage may occur.

Remove the front door trim panel.

• Lift upward to remove the front door trim panel.

• Disconnect mirror adjustment switch electrical connector.

• Remove the front door handle.
  • Guide the door handle through the opening in the trim panel

Here are the instructions for the rear

1. Remove the inside door handle cover.
2. Remove the 2 inside door handle bolts.
3. Pull out the inside door handle and position the handle aside.
4. If equipped, remove the window control switch.
5. Remove the rear window rear garnish moulding.
   • Pull outward to release the garnish moulding clips from the door.
6. Remove the safety belt D-ring.
   • Remove the safety belt D-ring cover.
   • Remove the safety belt D-ring bolt.
     • To install, tighten to 40 Nm (30 lb-ft).
7. Remove the rear door front garnish moulding.
   • Pull outward to release the garnish moulding clips from the door.
8. Remove the rear door trim panel screw covers.
9. Remove the 5 rear door trim panel screws.

10. NOTICE: Do not pull directly outward on the rear door trim panel, as damage may occur.

    Remove the rear door trim panel.
    • Lift upward and remove the rear door trim panel.