How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask HDGENE Your Own Question
HDGENE, Ford Senior Master/Diesel/Trans
Category: Ford
Satisfied Customers: 4782
Experience:  25 years Auto experience, Ford ,GM, Chrysler, Asian & European
Type Your Ford Question Here...
HDGENE is online now
A new question is answered every 9 seconds

How do you bleed cooling system after draining to change thermostat.

Resolved Question:

How do you bleed cooling system after draining to change thermostat. 96 Lincoln Mark V111
Submitted: 7 years ago.
Category: Ford
Expert:  HDGENE replied 7 years ago.
There is no specific air bleeds to be open, the system is supposed to send entrapped air back to the resouvoir tank. Run the vehicle with the heater on full blast and run the engine rpms up until you get good heat flow, run it with the cap off but watch you dont make a mess with the coolant level bubbling over. Once you have full heat you should have all air removed from the system.usually takes a few minutes, just watch your temp gauge, the cooling fans should come on usually when the thermostat opens and full circulation occurs in the system.
HDGENE and 2 other Ford Specialists are ready to help you

Related Ford Questions