How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask fordman312009 Your Own Question
fordman312009
fordman312009, Ford Technician
Category: Ford
Satisfied Customers: 485
Experience:  all ford training done asset grad.
17025784
Type Your Ford Question Here...
fordman312009 is online now
A new question is answered every 9 seconds

Ignition coil change on 2005 ford taurus

Customer Question

ignition coil change on 2005 ford taurus
Submitted: 7 years ago.
Category: Ford
Expert:  fordman312009 replied 7 years ago.
what cylinder ? and what engine
Expert:  fordman312009 replied 7 years ago.
Ignition Coil-On-Plug — LH      Printable View (160 KB)

Material Item Specification
Silicone Brake Caliper Grease and Dielectric Compound
D7AZ-19A331-A ESE-M1C171-A

Removal and Installation

Disconnect the electrical connector from the ignition coils.

NOTE: When removing the ignition coils, a slight twisting motion will break the seal and ease removal.

Remove the bolts and the ignition coils.

To install, reverse the removal procedure.
Apply a light film of Silicone Brake Caliper Grease and Dielectric compound D7AZ-19A331-A or equivalent meeting Ford specifications ESE-M1C171-A to the inside of the coil boots before installation.


Ignition Coil-On-Plug — RH      Printable View (160 KB)

Material Item Specification
Silicone Brake Caliper Grease and Dielectric Compound
D7AZ-19A331-A ESE-M1C171-A

Removal and Installation

Remove the upper intake manifold. For additional information, refer to Section 303-01B.
Disconnect the electrical connectors from the ignition coils.

NOTE: When removing the ignition coils, a slight twisting motion will break the seal and ease removal.

Remove the bolts and the ignition coils.

To install, reverse the removal procedure.
Apply a light film of Silicone Brake Caliper Grease and Dielectric compound D7AZ-19A331-A or equivalent meeting Ford specifications ESE-M1C171-A to the inside of the coil boots before installation

Ignition Coil      Printable View (166 KB)
Removal and Installation

CAUTION: It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.

Disconnect the spark plug wires by twisting while pulling upward.

Disconnect the electrical connector from the ignition coil.

Remove the ignition coil.
Remove the bolts.
Wipe the ignition coil towers with a clean cloth dampened with soap and water.

CAUTION: Spark plug wires must be connected to the correct ignition coil terminal.

To install, reverse the removal procedure.


here ive sent you the directions for the 3.0 2v and the 3.0 4v i hope it helps you out please leave feedback if it helps you and i'll do the same thank you and good luck