Ok.

The special tool is what Ford Uses, but I have found that a door panel tool works well also.

Glow Plug

Special Tool(s)

Remover/Installer, Glow Plug Connector (NNN) NNN-NNNN/td>

Material

Item	Specification
SAE 15W-40 Super Duty Motor Oil XO-15W40-QSD or equivalent	WSS-M2C171-D

Removal

LH side

1. Remove the air cleaner. RH side
2. Remove the RH fender splash shield. Both sides

3. NOTICE: Do not pull on the wiring to remove the glow plug connector or damage may occur.

   NOTE: Only one glow plug connector shown.

   Using the special tool, remove the glow plug harness.

1. NOTE: If coolant residue is found on the glow plug, a new glow plug sleeve may have to be installed. Remove the glow plug.

Installation

Both sides

1. Install the glow plug.
   • Tighten to 19 Nm (14 lb-ft).

1. Clean and apply clean engine oil to the O-ring seals.

1. Using the special tool, install the glow plug harness.

RH side

1. Install the RH fender splash shield.

LH side

1. Install the air cleaner.

Thank You and Good Luck

"E"