How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Kenny Z. Your Own Question
Kenny Z.
Kenny Z., Ford Senior Master Tech
Category: Ford
Satisfied Customers: 5235
Experience:  Auto Trans, Drivability and Electrical Specialist
9600325
Type Your Ford Question Here...
Kenny Z. is online now
A new question is answered every 9 seconds

2008 Mustang GT: the front turnsignal assembly

Resolved Question:

I need instructions on how to change the front turnsignal assembly on a 2008 Mustang GT
Submitted: 7 years ago.
Category: Ford
Expert:  Kenny Z. replied 7 years ago.

Hello and thanks for your question.

 

Side Lamp/Front Turn Signal Lamp

 

graphic

 

Removal and Installation

 

Remove the front fender splash shield

 

graphic

 

ItemPart NumberDescription
1 W706805 Fender splash shield screws (3 required)
2 16K194 Fender splash shield pin-type retainer (front) (5 required)
3 16B568 Fender splash shield (front)
4 W709176 Rocker panel pin-type retainers (2 required)
5 16K194 Fender splash shield pin-type retainer (rear) (2 required)
6 16B568 Fender splash shield (rear)

 

  1. Remove the 3 front fender splash shield screws.
  2. Remove the 5 pin-type retainers and the front fender splash shield.
  3. Remove the 2 pin-type retainers and position the rocker panel aside.
  4. Remove the 2 pin-type retainers and the rear fender splash shield.
  5. To install, reverse the removal procedure

Release the 2 locking tabs and remove the front side marker lamp assembly.

  • Disconnect the electrical connectors

graphic

To install, reverse the removal procedure

Kenny Z. and 7 other Ford Specialists are ready to help you