How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask Pete Your Own Question

Pete
Pete, Electronic Engineer
Category: Exercise Equipment
Satisfied Customers: 15773
Experience:  Over 16 years of experience installing and repairing electronics.
30970729
Type Your Exercise Equipment Question Here...
Pete is online now
A new question is answered every 9 seconds

Vision fitness t9600 trwadmill does not go to zero after

Customer Question

vision fitness t9600 trwadmill does not go to zero after auto calibration then I get an E4 error
Submitted: 1 year ago.
Category: Exercise Equipment
Expert:  Pete replied 1 year ago.
Hi there,
E4 indicates an elevation motor position sensor problem.
Check that the new motor and existing sensor are correctly aligned.
Clean the sensor, adjust as necessary, and try again.
If the problem persists, the sensor may be faulty and will need to be replaced.