How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask Pete Your Own Question

Pete
Pete, Electronic Engineer
Category: Consumer Electronics
Satisfied Customers: 16511
Experience:  Over 16 years of experience installing and repairing electronics.
30970729
Type Your Consumer Electronics Question Here...
Pete is online now
A new question is answered every 9 seconds

My Optoma Dlp worked great until last night. When I turned

Customer Question

My Optoma Dlp worked great until last night. When I turned it on It would no longer receive an image from the source
Nothing had been change from the previous hour. I bypassed the receiver thinking that might be it but still showed "no display" The Hdmi cable is heavy duty and all connections are good.
Any thoughts or direction would be beneficial
Submitted: 7 months ago.
Category: Consumer Electronics
Expert:  Pete replied 7 months ago.

Hi there,

Try using a different HDMI cable and a different input source device.

If that doesn't work, test the other input types.

If you still get "no display" showing then there is likely a fault on the main board - this can happen suddenly and unexpectedly without warning/

Expert:  Pete replied 7 months ago.

Hi, just checking in on your question, do you need any further assistance?