How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask ITPeter Your Own Question

ITPeter
ITPeter, Electronics Engineer
Category: Electronic Musical Instruments
Satisfied Customers: 15773
Experience:  Over 16 years' experience in installing and repairing electronics.
30970729
Type Your Electronic Musical Instruments Question Here...
ITPeter is online now
A new question is answered every 9 seconds

Have a camm 1 servo - gx24 I am getting a motor error when

Customer Question

have a camm 1 servo - gx24
I am getting a motor error when I down load data - or the vinyl spins out - at as very high speed
using xp
Submitted: 1 year ago.
Category: Electronic Musical Instruments
Expert:  ITPeter replied 1 year ago.
Hi there,
The Motor Error can be caused by the size of the vinyl roll. On large rolls the material can be too heavy for the cutter motor to pull the roll and you will get a motor error. To avoid this, always making sure there is a long loop of vinyl between the cutter and the roll.
If leaving a loop does not help then it could also be due to a dirty material sensor. Tr using a dry Q-tip to clean the sensors at the back and front of the cutter.

Related Electronic Musical Instruments Questions