How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, Chrysler/Dodge/Jeep master tech
Category: Dodge
Satisfied Customers: 21573
Experience:  ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans and Hybrid Specialist
9825021
Type Your Dodge Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

No cruise control, 3.9 l have not found fuse, 1999 dodge

Customer Question

no cruise control
JA: Have you checked the fuse? What size is your engine?
Customer: 3.9 l have not found fuse
JA: What is the model/year of your Dodge?
Customer: 1999 dodge dakota
JA: Are you fixing your Dakota yourself? What have you tried so far?
Customer: i changed the switch on brake pedal i changed the switch on steering wheel and changed the clock spring and changed the servo module checked tail lights and looked for vacuum leak every once in a while licht on dash will come on when i hit the switch for about a second
JA: Anything else you want the mechanic to know before I connect you?
Customer: thing i have not changed is speed sensor
Submitted: 15 days ago.
Category: Dodge
Expert:  sprinkles08 replied 15 days ago.

Hello and welcome to JustAnswer!

If the light comes on initially but goes out it is often due to a servo circuit issue. You've replaced most of the components in the circuit so there isn't alot left as far as dedicate cruise components other than wiring. The problem may not be directly related to a cruise component however, there are many other seemingly unrelated things that can disable cruise.

The first step in diagnosing the problem is to use a scan tool or code reader to see if any fault codes are setting. Have you checked for codes?

Customer: replied 13 days ago.
checked codes I had a p1595
Customer: replied 13 days ago.
If it is wires is there a schematic I could use
Expert:  sprinkles08 replied 13 days ago.

This code could be caused by quite a few things.

Do you have a scan tool to actuate the servo solenoids?

Customer: replied 13 days ago.
No I don't have that kind
Expert:  sprinkles08 replied 13 days ago.

Do you have a digital voltmeter and test light?

Customer: replied 13 days ago.
I have voltmeter and light
Expert:  sprinkles08 replied 13 days ago.

The first thing you'll want to do is unplug the servo and start the engine. Have a helper press and continue to hold the cruise button to the on position. Is there power on the dark blue/red wire?

Customer: replied 13 days ago.
If no power then what if they hit on button should light on the dash come on???
Expert:  sprinkles08 replied 13 days ago.

You're not concerned with the light. You're holding the button to see if there is power at the servo. If there is none then it will need to be tested at the PCM connector.

Customer: replied 8 days ago.
Can't check voltage now
Expert:  sprinkles08 replied 8 days ago.

Ok.

Related Dodge Questions